9 replies to this topic

[dangermouse]

Seeing as this tool doesn't seem to be available anywhere, you can now find it here.




EDIT by Ginetto: You now find the grved111.zip below; it contains the installer for Goove Editor and it should work as is (I use it all the time).
It has the regional decimal point problem fix included so you probably shouldn't need any of the other 2 rar attached.

Attached Files

•  runtime_install___only.rar   20.75MB   286 downloads
•  regional_decimalpt_fix.rar   513bytes   151 downloads
•  grved111.zip   6.8MB   70 downloads

Edited by Ginetto, Dec 07 2013 - 05:51 PM.

[pirenzo]

cheers Keith, could use this.

[pirenzo]

Do you happen to have the runtime setup file as well?

It is mentioned in this thread
https://forum.rscnet....highlight=GrvEd


It seems at some point the two installs were separated into different downloads.

[Bill]

exellent tool, seems to me I have all the nessasary files, I will look

[dangermouse]

Bill, on Aug 11 2006, 12:51 AM, said:

exellent tool, seems to me I have all the nessasary files, I will look

<{POST_SNAPBACK}>

Thanks Bill  

[pirenzo]

Thanks alot Bill

[Remy]

Could someone re-upload this utility please? dl link doesn't work

Thanks

[ginetto]

Remy , now it should work
I uploaded the correct installer ( grved111.zip 6.8 MB)

[Remy]

Thank you Ginetto

[ljmagyar]

Does anyone have a tutorial, notes, or even a quick 'nudge in the right direction on how to work the Groove Editor?  I can make the cursor move, add noise, remove noise, and zoom in/out.  As for aligning the groove ends, smoothing out anomalies, or anything else, no matter how many buttons I press, I cannot stumble across getting anything done.